Site design by ETC

Coin Operated Timers
Back
Converting
Solid State
HM5
HM6
Meters
   Support | FAQ | Contact

Accumulating Totalizing Timer Single Input With Alarm

Coin Operated Timer
    Features

  • Single Input
  • Two time ranges
    1 minute intervals to 31 minutes - 5 minute intervals to 160 minutes - per impulse
  • Accumulation of time
    Each coin will add to the total based on time settings
  • Counts coins, up to 8 to start
    Field adjustable
  • Output for audible or illuminating warning
    One amp steady state, 10 amp inrush - SPST output - Field adjustable - From 1 to 4 minute on short range timer - From 2 to 8 minute on long range timer
  • Available in 24 VAC or 110 VAC
    Other voltages available on special order
  • Uses solid state switch with 1 amp capacity
    One amp steady state, 10 amp inrush
  • On-board varistor to protect from current spikes
  • Accurate, potted, durable solid state circuitry




Accumulating Totalizing Timer
Single Input with Alarm

 OPERATION: Input voltage must be maintained between N and L1 prior to and during operation. Terminal C1 is to the switch on the coin mechanism. Time settings are made by the appropriate combination of the first 5 DIP switches on the timer. The duration of the alarm is set on switches 6 & 7. Switches 8, 9 & 10 set the number of impulses to start.

Output voltage for the alarm matches operating voltage and primary for the timer. Maximum load on either terminal is 1 amp steady, 10 amp inrush. Loads exceeding these limits should be operated through an appropriate contactor. Monarch also has audible alarms appropriate for use with this timer, or you may choose your own light, horn or buzzer.

Accumulating Totalizing Timer Single Input with Alarm AVAILABLE IN:

P/N TL2-24S-2564A-5 110VAC - 1 minute increment

P/N TL2-24S-2564A-7 110VAC - 5 minute increment

P/N TL2-23S-2564A-5 24VAC - 1 minute increment

P/N TL2-23S-2564A-7 24VAC - 5 minute increment